The box should contain 10 separate pieces comprising 2 arm rest covers, 1 double seat base cover, 1 single seat base cover, 3 seat back covers and 3 head rest covers.
Remove all the head rests then fit the nearside seat base cover. Tilt the back of the seat forward and push the cover through to the back.
Mate the Velcro straps as shown in the picture below.
Open the Velcro seam on the seat back and fit it to the seat.
Slide the cover behind the seat belt and re-make the Velcro seam down the back of the seat.
Next, make up the horizontal seam to complete the seat back.
Fit the double seat base cover again tilting the seat forward and pushing the cover through to the back.
Mate the Velcro straps at the back of the seat.
Fit the cover over the centre seat back in the same manner as before, passing the cover under the seat belt and re-making the Velcro seam down the back of the seat.
Repeat this process for the final seat back and then make up the Horizontal seams.
Now fit the head rest covers.
Finally fit the arm rest covers and the job is finished.